Posts: 244
Threads: 28
Joined: Dec 2022
Reputation:
8
07-14-2023, 12:25 AM
(This post was last modified: 07-14-2023, 01:42 AM by Froggie.)
Since December, I have used both the produced ISO (USB) and the BOOT.wim contained in the ISO as a BCD BOOT menu item... both have successfully EXITed (using the CLOSE button) from their running state after a few seconds.
v3.6, in both forms mentioned above, doesn't ever EXIT... it remains at a BLACK screen with the mouse pointer visible. A HARD machine ShutDown seems to be the only way past this state.
Posts: 244
Threads: 28
Joined: Dec 2022
Reputation:
8
OK, this time a little more "controlled" test.
v3.5 ISO (USB): 8-sec from close to hardware restart with cursor on screen (consistent over 10-tries)
v3.6 ISO (USB): 90-sec from close to hardware restart with cursor on screen (consistent over 10-tries <didn't wait long enough during initial reported test>)
I will also look into the status of my hardware as I have also seen an occasional anomaly recently with normal System restarts (unexpected delay).
Posts: 75
Threads: 11
Joined: Feb 2023
Reputation:
0
@Froggie
Are you referring to closing the Hasleo GUI after entering Hasleo WinPE?
I don't have any freezing or delay problems with v3.6 on fully updated Windows 11, but I haven't tested it with a bootable USB.
Posts: 244
Threads: 28
Joined: Dec 2022
Reputation:
8
On this System it happens using the WIM or the ISO (I'm sure it's a WIM-based issue), BUT... the System may have some really wierd reBOOT issue as well. Am looking into it.
Posts: 244
Threads: 28
Joined: Dec 2022
Reputation:
8
Great job, works now as it originally did! Thank you very much!
