05-29-2023, 02:18 AM
Greetings! My first attempt at using the CLI was apparently very successful... tying a CLI Differential creating command to an event trigger (USB discovery) via pre-Command w/Powershell.
I then set up a DAILY Incremental task. When I try to execute a CLI image creation based on that task, It appears to run to about the 46% point then ends in failure, although it appears that the requested image was created. The CLI command is below, along with the error from the LOG. I'm using the same Powershell successful script mentioned above. Any idea what's going on?
CLI: BackupCmdUI.exe /a run /g 9CE52D55-0C5F-44D9-B700-3198EC9E0A3C /t 2
LOG error: The handle is invalid. (0x00A5001200000000), The task failed with 0x00A5001200000000.
...additional DataPoint, both the scheduled version and the manual version work fine on that task.
I then set up a DAILY Incremental task. When I try to execute a CLI image creation based on that task, It appears to run to about the 46% point then ends in failure, although it appears that the requested image was created. The CLI command is below, along with the error from the LOG. I'm using the same Powershell successful script mentioned above. Any idea what's going on?
CLI: BackupCmdUI.exe /a run /g 9CE52D55-0C5F-44D9-B700-3198EC9E0A3C /t 2
LOG error: The handle is invalid. (0x00A5001200000000), The task failed with 0x00A5001200000000.
...additional DataPoint, both the scheduled version and the manual version work fine on that task.