Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Windows 7 Install Reaches Boot Screen, Then Dies
#8
(03-27-2020, 12:39 PM)jfk52917 Wrote:
(03-27-2020, 12:27 PM)admin Wrote:
(03-26-2020, 09:27 PM)jfk52917 Wrote:
(03-26-2020, 07:44 PM)admin Wrote:
(03-26-2020, 05:36 PM)jfk52917 Wrote: I was actually using Windows 7 Ultimate, which it appears should work. That being said, I may try using Windows 8 instead, though I think I'd prefer to use 7, if possible.

Is the USB drive an external hard disk or a USB flash drive? Some computers produced in recent years may not be compatible with Windows 7. Are you sure your computer is compatible with Windows 7?

The drive is USB flash, unfortunately. I would imagine that my computer is compatible - it's a fairly moderate-spec laptop from 2015 with Windows 10 as its native OS, but dual-booting that and Manjaro Linux.

Please note that Windows 7 does not have built-in USB 3.0 support, you can only start Windows 7 To Go from the USB 2.0 port, please check it.

Yeah, I had noticed that, too. The first time I tried, I did use the USB 3.0 port on my computer, but when that failed, I used a 2.0 instead, but that also failed in the same way. Unfortunately, I reformatted the drive and used 8.1, but that also didn't work (at least installing it under the GPT settings) - after rebooting and selecting the USB as a start device, the computer spent about an hour setting up the drive, but never actually booting to Windows. Are there any requirements for the drive used when creating a Windows To Go installation?

We think the reason why Windows runs slowly is because the USB flash drive you used is too slow or you have inserted the USB drive into a very slow USB port (such as USB 1.0, 2.0). For a Windows operating system boot drive, the 4K random read/write speeds are very important. Usually the 4K read/write speeds of the common flash drives are always slow, so these drives are not suitable for creating portable Windows. We highly recommend using a Windows To Go Certified Drives or external hard drive to create Windows To Go. For Non-certified USB flash drive, we recommend you to buy a Corsair Flash Voyager GTX Flash Drive, SanDisk Extreme CZ80 USB 3.0 Flash Drive or SanDisk Extreme PRO CZ88 USB 3.0 Flash Drive, we've done a lot of testing, they're fast enough to run Windows smoothly and more cheaper. If you want small size and high performance, Corsair Flash Voyager GTX Flash Drive is the best choice.
Reply


Messages In This Thread
RE: Windows 7 Install Reaches Boot Screen, Then Dies - by admin - 03-27-2020, 01:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)