error cloning windows 7 starter

[feeldumb]

Ok, I ran WinToUSB again.

wintousb
11:44 AM 5/4/2016
wintousb clone
Microsoft Windows 7 Starter (x86)
6.1.760 Build 7600
C:, NTFS, Used: 22.17 GB, Capacity: 80.00 GB
Legacy BIOS
next
11:45 AM 5/4/2016
formating
11:45 AM 5/4/2016
system and boot
11:46 AM 5/4/2016
reboot required
and says success!

So, thinks it worked, no error messages.

So, I tell laptop to boot from USB.

Says OK, booted up. little slow.

But, just like last time, C: disk is NOT the USB.

When I run cmd as administrator, and do "set" get weird mix.

cmd opens in

USERPROFILE=C:\Users\Honey
windir=E:\Windows

E:\Windows\system32>

E: is usb

and set gets:

E:\Windows\System32 Wed 05/04/2016 13:58:29.41
>set
ALLUSERSPROFILE=E:\ProgramData
APPDATA=C:\Users\Honey\AppData\Roaming
CommonProgramFiles=C:\Program Files\Common Files
COMPUTERNAME=HONEY-PC
ComSpec=E:\Windows\system32\cmd.exe
configsetroot=E:\Windows\ConfigSetRoot
FP_NO_HOST_CHECK=NO
HOMEDRIVE=C:
HOMEPATH=\Users\Honey
LOCALAPPDATA=C:\Users\Honey\AppData\Local
LOGONSERVER=\\HONEY-PC
NUMBER_OF_PROCESSORS=2
OS=Windows_NT
Path=E:\Windows\SYSTEM32;E:\Windows;E:\Windows\SYSTEM32\WBEM;E:\Windows\SYSTEM32
\WINDOWSPOWERSHELL\V1.0\;C:\Program Files\Calibre2\
PATHEXT=.COM;.EXE;.BAT;.CMD;.VBS;.VBE;.JS;.JSE;.WSF;.WSH;.MSC
PROCESSOR_ARCHITECTURE=x86
PROCESSOR_IDENTIFIER=x86 Family 6 Model 28 Stepping 10, GenuineIntel
PROCESSOR_LEVEL=6
PROCESSOR_REVISION=1c0a
ProgramData=E:\ProgramData
ProgramFiles=C:\Program Files
PROMPT=$P $D $T $_$G
PSModulePath=E:\Windows\system32\WindowsPowerShell\v1.0\Modules\
PUBLIC=E:\Users\Public
SystemDrive=E:
SystemRoot=E:\Windows
TEMP=C:\Users\Honey\AppData\Local\Temp
TMP=C:\Users\Honey\AppData\Local\Temp
USERDOMAIN=Honey-PC
USERNAME=Honey
USERPROFILE=C:\Users\Honey
windir=E:\Windows

E:\Windows\System32 Wed 05/04/2016 13:58:34.23

So, did it boot from clone on USB or what?
Is this a bootable USB or not?

I am thoroughly confused now.