+- Hasleo Software Forums (https://www.easyuefi.com/forums)
+-- Forum: Hasleo Software (formerly called EasyUEFI Development Team) (https://www.easyuefi.com/forums/forumdisplay.php?fid=1)
+--- Forum: WinToUSB (Best Windows To Go Creator) (https://www.easyuefi.com/forums/forumdisplay.php?fid=2)
+--- Thread: i can't seem to boot wintousb (/showthread.php?tid=2520)
i can't seem to boot wintousb - Befer1999 - 03-12-2025
i've been +using wintousb for a year now, and today i can't seem to boot, as there's a bcd error right after the manufacturer's logo. the error says "the boot configuration data file does not contain valid information" this was caused actually by me accidentally deleting my bcd via easybcd. i've tried rebuilding it through command prompt, but i get an error also that cannot find the path specified after using bootrec /rebuildbcd. any help would be appreciated.
RE: i can't seem to boot wintousb - admin - 03-12-2025
(Yesterday, 04:45 PM)Befer1999 Wrote: i've been +using wintousb for a year now, and today i can't seem to boot, as there's a bcd error right after the manufacturer's logo. the error says "the boot configuration data file does not contain valid information" this was caused actually by me accidentally deleting my bcd via easybcd. i've tried rebuilding it through command prompt, but i get an error also that cannot find the path specified after using bootrec /rebuildbcd. any help would be appreciated.
Please try the steps below to rebuild the BCD file:
1. Assign drive letters to (EFI) system partition and the boot partition on the physical USB drive. In this example, the system partition is I: and boot partition is J:.
2. Run cmd.exe as a administrator, then run 'bcdboot J:\Windows /s I: /f all'. Please note that if you assign different drive letters to these partitions, you should replace them with your own drive letters on the command line.
If the boot files created successfully, then try to boot Windows from this USB drive.